View Single Post
Old 01-18-2017, 11:58 PM   #103
Senior Member
Join Date: May 2009
Location: No longer here
Posts: 6,255
Re: 4L80E & TH400 Tech.

Originally Posted by softballnrd27 View Post
Not sure if you covered this or not but what is the best way(right way) to convert from the bolt on yoke to a slip yoke on a 1998 4l80e? I ordered a a slip yoke that fits the trans but it doesn't seem like it allows enough slip.
I have not......

The easiest thing to do is run a short "Counter Bored" Yoke,

The "Correct" way & a Must for vehicles with a lot of suspension travel is to machine off the O-ring boss & run a long full spline Yoke.

The "Best" thing to do.....Buy a Core with a Full Splined Output Shaft to start with.

clinebarger is offline   Reply With Quote