Quote:
Originally Posted by rbar
If it was me, I would shorten the frame like they did on trucks and then buy the two bed sides from MAR-K. They make nice stuff and you could pick up a pair of steps and be done. If not, cutting the step side bed down would still be easier than a fleetside. I think you would have to remove the same amount on both ends that you do on a fleetside
Posted via Mobile Device
|
THAT is an excellent idea. Never thought of that. One question - I don't know the "where" point where it should be cut. But by looking at a long step - it always appeard to me that the distance between the back of the step fender and the rear of the bed always looked the same on a long or short step - i.e. always looked to me that the "long" of the long step was all inserted in front of the fender. But again - you know what they say about A$$uming... Interested to see how this goes!