The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

zammer · 02-20-2010, 08:13 PM

Thanks guys, thats exactly what is was wondering and looking for..
The only problem I have now is I can't really mount an external slave cylinder as I got a set of those Sanderson shorty headers from ECE and they don't fit around the stock Z bar AND... they dump right above the fork so its pretty hard to get a bend in there to clear the fork and linkage, an external slave to be almost impossible as they hug the block.
What kind of hydraulic internal / throwout bearing can i use??? Anyone use something on there manual trans instead of the stock fork??
My 4 speed is dated around 1977.. not sure if this matters or not.

02-20-2010, 08:13 PM	#24
zammer Addicted user Join Date: Sep 2009 Location: Edmonton, Alberta Posts: 369	Re: Hydraulic Clutch Conversion 1965C10 Thanks guys, thats exactly what is was wondering and looking for.. The only problem I have now is I can't really mount an external slave cylinder as I got a set of those Sanderson shorty headers from ECE and they don't fit around the stock Z bar AND... they dump right above the fork so its pretty hard to get a bend in there to clear the fork and linkage, an external slave to be almost impossible as they hug the block. What kind of hydraulic internal / throwout bearing can i use??? Anyone use something on there manual trans instead of the stock fork?? My 4 speed is dated around 1977.. not sure if this matters or not.