Quote:
Is that your controller sitting at the back on the drivers side of the engine?
|
that's it. the cpu is only 3''x3'' the big thing are the plugs that would need 'uge holes in the firewall
Quote:
I had a TH400 in for my previous mockup and now have the 700r4 sitting in there
|
i used a th350 that fit fine, the bell housing must be a bit bigger on top, i only modified the cover
i welded the cover in after fitting it, no need to service the toploader trans anymore
Quote:
I know I will have more questions on the engine and trany hookup
|
the ramjet is pretty well plug-n-play, the only real problem i had was timing as it only has tdc marks
you need to find a timing light that is
+ adjustable, none of mine or my friends were adjustable
the wiring harness is foolproof with single purpose plugs for each item spidering out from the cpu
i move the knock sensor to a hole over the oil filter to clear block hugger headers, so figure out what headers you plan to use
i just read today that you had done a frame swap, read my signature and put your build thread into your signature
fyi: the ramjet came just as you see it here (minus trans
)
w/ pan, rocker covers, spark plugs, distributor and even the air filter installed