The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Andy4639 · 10-22-2011, 11:23 AM

So you wouldn't be scared the stuff pushes out the hood when it rises. I was thinking tape one side of the brace off and fill with this stuff would help. Then cut off the rest that extends past the brace edge. This would also give it some place to go besides up. It will go to the least resistance right. So if one side is left open the foam would not push the hood away from the brace just fill the area between.

10-22-2011, 11:23 AM	#21
Andy4639 Old member Join Date: Jan 2002 Location: Liberty, & Garden City S.C. , U.S. Posts: 19,936	Re: hood vibrate solution So you wouldn't be scared the stuff pushes out the hood when it rises. I was thinking tape one side of the brace off and fill with this stuff would help. Then cut off the rest that extends past the brace edge. This would also give it some place to go besides up. It will go to the least resistance right. So if one side is left open the foam would not push the hood away from the brace just fill the area between. __________________ 1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver Seeing the USA in a 71 Upstate SC GM Truck Club 2013,14 and 2016 Hot Rod Pour Tour http://upstategmtrucks.com/ Get out and drive the truck this summer and have some fun! It sucks not being able to hear! LWB trucks rule, if you don't think so measure your SWB! After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs.