The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Sheenanny · 05-23-2002, 06:32 AM

I found out that it was the fan switch that was blowing my fuses. Got a new switch and now it only works on high. Also, when I had the heater & A/C control panel loose from the dash to put in the new switch, I noticed one of the vacum lines is missing and another is cut right outside the firewall. I don't know where the heck these are supposed to plug in. Does anybody know where I might find a vacum line routing diagram or anything that might help?
Thanks so much!

05-23-2002, 06:32 AM	#1
Sheenanny Registered User Join Date: May 2002 Location: Lexington, KY Posts: 23	Update I found out that it was the fan switch that was blowing my fuses. Got a new switch and now it only works on high. Also, when I had the heater & A/C control panel loose from the dash to put in the new switch, I noticed one of the vacum lines is missing and another is cut right outside the firewall. I don't know where the heck these are supposed to plug in. Does anybody know where I might find a vacum line routing diagram or anything that might help? Thanks so much!