Re: Roadkill's 58 Chevy Stepside
I found some time to work on the truck.
Set the front tin on the chassis, and held it on with four bolts.
I had measured and marked where I needed to cut the inner fenders to
clear the upper suspension. It seems I was a little too conservative with my cuts.
Cut a little more off, and then welded some round stock to the cut edge.
Still a little touch up to do, and then some paint.
I have to run the head light, and parking/turn signal wire across, and add
the weather-pak connectors to both ends before setting the front tin back on.
The head light, and parking/turn signal wires will be hidden from view under
the hood. Once the head lights are wired up I can start on the bed again.
If I'm lucky the A-arms will clear the inner fender under compression.
.
|