Quote:
Originally Posted by smoknbarrels
Thanks!
Never heard of evercoat s s, what is it?
My biggest problem is welding my body panels, even using .023 wire on the lowest heat setting, doing a few spots at a time far apart, still warps like crazy!? Its frustrating me like unreal. I tell ya, if a real bodyman seen what i did to perfectly new bedsides, he'd have a few sighs..
Posted via Mobile Device
|
Instead of me writing out all this, here is a link to the tech sheets
I use this product after i have my bodywork dialed in.
http://evercoat.com/imgs/pis/SLICKSANDPIS.pdf
I would also recommend using a epoxy primer on all your metalwork or bare metal spots before you apply any fillers.
As for fillers i like to use a skim coat of evercoat everglass over all my metalwork areas. Lets say you have a pinhole you missed welding up the everglass will resist moisture where bondo or filler will absorb the moisture.
After you layed down a skim coat of everglass and sanded it, you can use your choice of fillers. I perfer rage gold or extreme body filler(nice stuff to sand).
In no way am i telling you how to do your build but offering some advise that i have used for many times and had great results.