|
Re: tilt column swap question
as to pulling apart the column to change the ignition switch its pretty simple with the right tools... pull off the wheel use the compressor to compress the piece under the wheel.. remove the retaining clip, and once you slide out the turn signal switch there are pins or screws that hold in the ignition key switch
__________________
Bob
1951 International running on a squarebody chassis
"If a man's worth is judged by the people he associates himself with, then i am the richest man in the world knowing some of the fine people of this board"
http://67-72chevytrucks.com/vboard/a...t.php?f=25&a=9 (you can review the site rules here!)
PM Me for your vehicle/parts hauling needs in the North East US or see my Facebook page Robert Olson Transport
Live each day to the fullest.. you never know when fate is going to pull the rug out from under you...
I hate cancer!!
|