[donandal]

Ok,
I'm on the road again tonight, and have a question about my
transmission control.

I have the Connect and cruise supermatic transmission controller
and the harness included a wire labeled "brake light".

The instructions read as follows;

2.2.9 Brake light wire
Although not necessary,the wire labeled "brake light" should be
run to a factory brake pedal switch (NC) so the TCC will unlock
When you apply the brakes.

The switch I have has six terminals, some NC and some NO.

Is the tranny looking for a 12 volt + positive or is it looking for
a ground to be supplied to this wire?

Thanks