The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

63frankintruck · 09-04-2019, 05:59 AM

Thanks! I have other issues that cause the rag joint to tear. Not sure what I’d going on. I installed a disk front end conversion kit from POW That uses original drag link. The tie rods in passenger side seem to be too long( wheel is turned somewhat while drivers side is straight and passenger side tie rods are adjusted to shortest length)
Anyway what started this whole thing was I was moving my truck without any engine or transmission in stalled and when I turn the wheel a couple times the rag joint just failed. It was a rebuilt rag joint. I’m not exactly sure what’s going on

09-04-2019, 05:59 AM	#9
63frankintruck Registered User Join Date: Oct 2015 Location: Keller, tx Posts: 426	Re: Powersteering box rag joint issues Thanks! I have other issues that cause the rag joint to tear. Not sure what I’d going on. I installed a disk front end conversion kit from POW That uses original drag link. The tie rods in passenger side seem to be too long( wheel is turned somewhat while drivers side is straight and passenger side tie rods are adjusted to shortest length) Anyway what started this whole thing was I was moving my truck without any engine or transmission in stalled and when I turn the wheel a couple times the rag joint just failed. It was a rebuilt rag joint. I’m not exactly sure what’s going on Last edited by 63frankintruck; 09-04-2019 at 07:51 AM.