Just a quick update...
Got rack installed. Should have been an easy job but required everything coming apart so I could 1.) install the lower A arm bolts in the right directions
and 2.) so it wouldn't damage any bushings with the heat. Also made cutting and welding in the frame notches easier. Then I had to shim the rack so it would fit. Oh well that's hot rodding.
I'm a little concerned that i'll have to cut the springs but I don't want to make that decision until the weight of the engine is over the front and that will be a long time... so I can either get working on finishing the engine (going for that retro LS look) or can get working on the rear even though the front isn't done.
Meh, i'll get it sorted out
Stay tuned...