Re: 1971 Stepside LS Build
Quote:
Are you using epoxy as your surfacer for blocking or are you laying down a urethane surfacer over the epoxy?
|
I'm using the PPG CRE epoxy. It is like spraying a thin filler coat and dries fairly hard and I'm told blocks out really well. I will block it and then do another round of this epoxy. Block again and then go with a urethane primer prior to paint.
__________________
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021.
"I can't complain, but sometimes I still do. Life's been good to me so far."
|