[jbgroby]

Step5: Accordion Felt

Next before you install the metal accordion felt, you’ll need to cut it to approximate length. On my 1960, I needed 54 ¼” long. This will be almost perfect and allow for a trim of a 1/8 at the top of the door by the vent. I used a pair of pliers to slightly bring the lower end together so I could start it past the door window opening. This is where the friend will come in - you will need to fit your arm through the large opening and feel as you push the accordion felt into place, make sure to seat it at the bottom on the brace BEHIND the clip. The using your hand, push the felt into the channel, you will need to use a bit of pressure to seat it correctly, but it hold in place very nicely. Leave the top section stand freely, you will seat it in a later step.