The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

sick454 · 08-08-2010, 08:40 PM

Well, I finally had time this weekend to install the harness, AND i'm frustrated again. I have everything exactly as Wait4me explained it. and labeled it. Except for the oil level sensor, I can't find it. before you go saying it. I have looked everywhere on the passangers side of the block and oil pan and it is not on my engine. Can this bebypassed and will it start without it connected

Second, The engine will not start. NO SPARK. I have fuel (plugs are wet with fuel) and it turns over but I can not get it to spark! Checked all my grounds and they are good. For some reason the PCM is not telling the coils to fire.

Any ideas?

08-08-2010, 08:40 PM	#11
sick454 Registered User Join Date: Apr 2008 Location: Converse, TX Posts: 49	Re: 5.3 SWAP Wiring Problem Well, I finally had time this weekend to install the harness, AND i'm frustrated again. I have everything exactly as Wait4me explained it. and labeled it. Except for the oil level sensor, I can't find it. before you go saying it. I have looked everywhere on the passangers side of the block and oil pan and it is not on my engine. Can this bebypassed and will it start without it connected Second, The engine will not start. NO SPARK. I have fuel (plugs are wet with fuel) and it turns over but I can not get it to spark! Checked all my grounds and they are good. For some reason the PCM is not telling the coils to fire. Any ideas?