Wiper switch & motor wiring - Is this correct?
1971 C-10
Lots of information on how these are wired. Some of it wrong, including a manual or two. At any rate, I'm hoping for confirmation or correction. Especially for operation of the Light Blue and Dark Blue wires. Thanks for any input.
Wiring: The following descriptions are from the top down for the switch in a mounted position.
18 AWG Light Blue: Operates the wipers (high/low). This wire runs to the dual pins on the RH (TS) portion of the motor.
18 AWG Dark Blue: Operates the washer. This wire runs to the dual pins in the bottom of the motor. NOTE: The bottom is the widest of the two dual connector/pins on the motor.
18 AWG Black: Ground wire. This wire connects to the single pin on the RH (TS) portion of the motor.
Other:
18 AWG Yellow: This wire runs from inside the fuse box to the connector on the bottom of the motor. A second yellow wire leads from this connector to the dual pin connector on the RH (TS) portion of the motor.
NOTE: Yellow was positioned on the bottom of both dual connectors.
TS means truck side.
__________________
Tony
71 Custom Deluxe, SWB, 2WD, 402, A/C. I developed an assm. guide "kit" for restoring it from ground up. With assys, the guide accts for 1000s details such as OEM identifications& part numbers, written in short order. 700+ images include assm, illust., charts, and points of interest. Much of the info. applies to all 67-72 GM trucks, and to a lessor degree all 67-72 GM vehicles. My build thread, and more on the guide https://67-72chevytrucks.com/vboard/...d.php?t=730025
Last edited by 71CHEVYSHORTBED402; 03-03-2017 at 08:40 PM.
|