The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - PROJECT: How would a Chevrolet dealer build a shop truck in the early 1970s?

**mattfranklin** · 02-25-2019, 06:13 PM

Next up, will be installing a fan shroud. Ordered one from LMC, about $80 taxed and shipped.

May add a thermostatic fan clutch like these guys recommend:
http://67-72chevytrucks.com/vboard/s...d.php?t=629097

And this is a good reference, too.
http://67-72chevytrucks.com/vboard/s...d.php?t=520163

AND, just might put it back on insurance this week and take it off of non-op registration.
Maybe a test drive soon.
Scary.

02-25-2019, 06:13 PM	#95
mattfranklin Senior Member Join Date: Dec 2011 Location: Moraga, CA Posts: 804	Re: PROJECT: How would a Chevrolet dealer build a shop truck in the early 1970s? Next up, will be installing a fan shroud. Ordered one from LMC, about $80 taxed and shipped. May add a thermostatic fan clutch like these guys recommend: http://67-72chevytrucks.com/vboard/s...d.php?t=629097 And this is a good reference, too. http://67-72chevytrucks.com/vboard/s...d.php?t=520163 AND, just might put it back on insurance this week and take it off of non-op registration. Maybe a test drive soon. Scary. __________________ (Very) Slow-Going Build Thread: Stock 1970 Short Step with Stock 1970 LT-1 http://67-72chevytrucks.com/vboard/s...d.php?t=567340 Last edited by mattfranklin; 03-02-2019 at 10:39 AM.