Re: Project "Steppin Wolf" LS swap
Quote:
Originally Posted by bnoon
Check out the last few pages of my build thread. The cheap eBay headers look the same as the ones I got from Amazon for 105 shipped. Don't fit unless you cut the passenger's side frame rail a bit.
|
just checked it out. my headers look nothing like the ones you used....even the exit comes out different. yours comes out more downward whereas mine comes out almost straight back. matter of fact, my passenger side header fits so tight against the block thats its actually touching the little pad on the block right above the crank sensor so I dont think theyll be an issue but we'll see. Also, my passenger side seems to be about an inch shorter than the drivers side and stops at the rear edge of the block whereas the drivers side goes an inch past that edge. Im thinking maybe thats to give more clearance for the flange but idk
Last edited by Liltroy; 05-29-2015 at 09:56 PM.
|