[robs71k5]

Sorry I will try to explain that portrait I in visioned now that I have a better understanding but before I do bare in mind that: I ordered my softopper with no holes drilled because I was uncertain of which holes belonged to what installation. So now I have installed my soft top rail flush with the inside edge of my quarter panel which may be correct but if I'm reading the picture the forward clip might need to be moved inboard more so that the window is just on the outside of the top and stays out side till it's at the top As it exists now my clip is 3/4 of an inch out board from where it should be. However that means I will have to make a bracket that moves the plastic pole retainer to the inside if the of the square tubes that came with softopper . Here is a picture that shows my window 3/4 of an inch inboard from my softop velcro strap now