View Single Post
Old 05-27-2014, 01:29 PM   #24
Registered User
Join Date: Feb 2013
Location: Phoenix AZ
Posts: 88
Re: Attempting my first build 72 K5

Originally Posted by 72K5CSTDarkOlive View Post
I used this grinder to cut the bolt off from both ends. Took a few minutes but it did the job.

I spent the next 5 hours underneath the truck with a high pressure steamer, degreaser, and lots of elbow grease to get all the crap that's been sitting on the underside of the bed and insine/outside of the frame rails.. Actually cleaned up real good.

If I had it my way, I would just take the body off the frame, but I have no place for it.
That's clean enough to eat off of. Did you have the factory asphalt undercoat on there?
sockalaminski is offline   Reply With Quote