|
Re: Fashionable Fever! - 1969 Chevy C10 Build
I pushed this off to the side for awhile so I could work on my "new" 67 I bought in early June. I'm at a standstill on that while I wait for the engine block to get professionally cleaned and checked.
It doesn't look like much, but anything helps right? It's taking me a little bit to make these pieces by hand. This is the drivers side now. I drilled a hole for the wire to run through the pillar to feed my cab roof lights. Just through in a 3/4" chase nipple so the wire won't rub against sharp metal and short out down the road. I also bent up the piece to tie back into the drip rail area. Just have to cut it down to fit and weld it in. Should be able to get that installed by the end of the week!
|