Re: Tubular engine mount crossmember??
Ok I see, either bolt to frame AND run bolts through the tube ends through the crossmember to or prevent twisting and movement. OR get someone to weld it all in for me.
If it's bolted... For the bolts to prevent movement...should I have horizontal and vertical bolts because the two tubes are not a tight fit? Are there any threads of anyone doing a bolt in?
For either way I go... I want to double check my facts.
When installing engine... do I get the crossmember as low in the rails as I can and just far back enough to be able to pull distributor? What is the gap goal between firewall and distributor cap?...350 engine with th350 trans
|