Bringing up an old thread, I know, sorry.
I just bought this kit from you and realized I have my motor mounts in the front two holes.
On
post 298 you mention the correct hole locations.
Just so I understand correctly the 7/8's hole is where the front bolt hole in the mount, then front mounting hole is in the frame, the back mounting hole is going through motor mount and the frame and the back motor mount hole is untouched. Is that correct? it'd look something like this?----->
. [O . .]
From left to right:
1. Front bearing mount hole
2. 7/8's hole for DD shaft
3. Back bearing mount hole (going through frame and motor mount)
4. Back motor mount hole (untouched)
Then you welded on the front of the motor mount (which would be the
[ in the pictogram above) to the frame for stability???