View Single Post
Old 05-30-2010, 04:32 PM   #1
Slow Build
Registered User
 
Slow Build's Avatar
 
Join Date: Sep 2009
Location: California Delta
Posts: 2,154
HEI install question (wiring)

I know this has been somewhat covered, but it's a bit confusing to me.

Doing the swap to HEI distributor slowly. I was wondering if I could do the wiring like I have in the diagram. Remove the 2 wires from the old coil then run new 12 gauge wire from the run terminal of the starter solenoid (where the yellow wire was connected) to the Bat+ terminal on the HEI. It seems to me that since the battery is connected directly to the solenoid with large cable that this would be a good source of 12 volt supply or would I be possibly overloading the wiring inside the solenoid itself. Any thoughts?
Attached Images
 
__________________
Name: Rich
Current Ride: 1964 C-10 Short Fleetside
Daily Driver: 2005 GMC crew cab short fleetside /2001 Chevy Tahoe
Past GM Trucks:
1959 GMC short stepside
1968 GMC short stepside-4x4
1973 Chevy short stepside
1989 Chevy short fleetside-reg cab
1993 Chevy short fleetside-Xcab
2002 Chevy short fleetside-Xcab

Save the dinosaurs, use synthetic oil.

Last edited by Slow Build; 06-08-2010 at 11:59 PM.
Slow Build is offline   Reply With Quote