[midniteblues]

after i started this thread i played around with this bar.
i just dont think it will work without moveing the shocks too the outside of the frame and the brake lines routed a differnt way than the way the factory did it.
i tried it completely reversed an up side down (my first thought) and the hoop on the bar just sitts too close too the ground for my likeing allthough its higher than my scrub line and my lower relocaters(lowest point) it being directly center an low just isnt good. It would fit great if i would've planned on useing it in the begining of the frame build but afterwards with all new stuff on the frame i'm not going back too remove/rework the lines an shocks

it should fit any leaf spring truck just fine as thats what it came from silly me for thinking it would fit my coil spring truck but i guess it doest hurt too try.

i did another seach here on the board and if its the same as the two others i saw here many pages back it looks as its a aftermarket bar that was sold for 4x4 leaf trucks I dont remember who made it though

I guessed i rolled around in the mud like a lil' piggy to get this off for somebody else's benifit

guys thanks for the bumps though