Quote:
Originally Posted by tinydb84
Measure the angle of the joint using the flat sides of the notch.
As for the 4 link, the brackets look to be made so that the triangle comes together at the rear. You might need to build a bar over the top of the rear to get the necessary triangulation you need to keep it centered (I recommend you do not weld the tabs to the center section directly).
|
Gotcha! And as far as the 4 link goes soo dont weld directly to the axle tube? Weld a tube style bar to the axle then weld to the brackets? The bottom bars have to be set parralel at ride height what about the smaller ones? Certain degrees also?