[mongocanfly]

not much done today..worked on the bumper dents ,bends ,and twists...started out by knocking all the big stuff out on my steel welding table with a 2lb hammer...a little shop press work ,some c clamps and twisting and its getting close...I guess it pays sometime to be a packrat..one of the wheels off a old junk floor jack fit the edge radius pretty close for hammering..I would find the high and low spots by rubbing a piece of flat soapstone over it to mark it so I'd know where to beat the living daylights outta it..need to test fit to see what else needs done and then some finish work...