The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

lutronjim · 08-10-2017, 08:21 AM

LMC has replacement relays on their site - if you want more of the same.

Found it was relay by swapping them.

I went to Summit and got a couple of spst relays. Had to solder and shrink rap new connectors. They have 5 pin connectors which seem to be standard on most relays. These have normal off and on - so I just clipped the normal on wire.

Using non relay low's would go back to using under gauge wire. I wouldn't think that would be good with the high amp blubs.

08-10-2017, 08:21 AM	#4
lutronjim Registered User Join Date: Dec 2013 Location: Dunwoody,Ga Posts: 443	Re: Bit by LMC again LMC has replacement relays on their site - if you want more of the same. Found it was relay by swapping them. I went to Summit and got a couple of spst relays. Had to solder and shrink rap new connectors. They have 5 pin connectors which seem to be standard on most relays. These have normal off and on - so I just clipped the normal on wire. Using non relay low's would go back to using under gauge wire. I wouldn't think that would be good with the high amp blubs.