[Matt_50]

Got an hour in today. I recut the outer skin about a 1/2 inch up. I used electrical tape, and carefully laid it around the curve and I got a nice straighter line. Previously I was just cutting out the rust and evaluating the inner piece.

Cut out a section and put in the piece I formed yesterday. I put it a vice to get my lip and then used pliers as a crude tucking fork. It required a lot of work to tuck then hammer then tuck and hammer to get a flat curved pieced, not perfect but not bad. I did lap weld it, not by much but this is a nice hidden area and having overlapping pieces or a backing piece sure has helped with my flux core welding and limited skills. I'll seal it real good.