Quote:
Originally Posted by slepysal
So I am not finding anyone who is willing to plane the boards down to 3/4". I was wondering if the following ideas would work. 1st. I could leave the new boards on top of my old plywood and secure them with strips an lag bolts through the plywood floor. Or 2nd. Cut a 1/4 " deep by 1" wide rabbet that would allow the wood to go under the bed frame bevel the edge and secure the boards with strips and blots. Again I appreciate any feedback positive or negative
|
I wouldn't think you'd have to plane the whole board down to 3/4", but just a grove at the bottom of the boards where the cross supports are.