[68 TT]

Originally Posted by Cdshinne

I cant take to much credit for the fab work all i did was cut out that section and ad a high hump tunnel from a 4x4 cab. I have seen the high hump tunnels in the sites classifieds for no more than $40.

Thanks, that helps a lot. I looked locally for quite a while but couldn't find a 67-72 part so I am fitting a newer one to my 67. I would like to get as close to the 67-72 look as I can so a stock carpet set might fit or at least be close.

I have a square body K10 high hump and a square body K5 one too plus the floor section that went around them. The K10 part is pretty close to the length of the stock 67-72 part and the side flanges line up with the 67 floor but the back does not transition down so I will have to fabricate the rear transition area to fit.