Quote:
Originally Posted by streetstar
Yes- it is safety wired incorrectly- the twisted wire should form an S of sorts as it pulls on both fasteners in the direction of tightening -- i'll try to post a diagram later
Build is lookinge great so far -- you'll be waking the neighbors for sure in that little mountain town
|
Well ****. That's what I get for trying to be extra safe. At least they are red loctited in.
I finally got the balancer off. Heat from a head gun did the trick.
I started today on the exhaust.
Does anyone think it matters where the bends in the system are located? What I mean is after the x pipe I turned the pipes up so they are level with the frame that way I don't need to bend it up over the axle. Does having the bends opposed to going straight until the axle hinder the flow?
Thanks
Paul
Posted via Mobile Device