The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

woodsrat · 09-25-2014, 02:27 PM

Had some more time again so I went back under this thing again.
Removed the front drive shaft to get into the shafts a little better then removed the lower detent switch (spring and ball) and still can't move the shaft at all.

Shift bar and linkage look different on mine, Hook is on the lower shaft and cross over plate is a pin type linkage on mine.
What should I try now?

09-25-2014, 02:27 PM	#98
woodsrat Registered User Join Date: Jul 2014 Location: st. Marys,Pa. Posts: 23	Re: NP 205 Rebuild and Info Had some more time again so I went back under this thing again. Removed the front drive shaft to get into the shafts a little better then removed the lower detent switch (spring and ball) and still can't move the shaft at all. Shift bar and linkage look different on mine, Hook is on the lower shaft and cross over plate is a pin type linkage on mine. What should I try now? Last edited by woodsrat; 09-25-2014 at 02:48 PM.