This all I got done yesterday.
20171008_141240 by
bjohnson388, on Flickr
20171008_154007 by
bjohnson388, on Flickr
But I did a little better today. Last day of vacation. Back to the rat race tomorrow.
20171009_090440 by
bjohnson388, on Flickr
20171009_090446 by
bjohnson388, on Flickr
20171009_093445 by
bjohnson388, on Flickr
All sanded down. Need to block them and put glazing putty in a few places and then one more coat of High build and block again and see where I am at.
20171009_092923 by
bjohnson388, on Flickr
20171009_093440 by
bjohnson388, on Flickr
Forgot to take a pic of the fender before high build.
20171009_104310 by
bjohnson388, on Flickr
20171009_104319 by
bjohnson388, on Flickr
20171009_104329 by
bjohnson388, on Flickr
Starting to look more like a truck.
20171009_110617 by
bjohnson388, on Flickr
Really proud of this Driver fender. It is by no means perfect but much better than the mess it was. Can't wait to get the driver door done.
20171009_110631 by
bjohnson388, on Flickr
20171009_110641 by
bjohnson388, on Flickr
Got 2 coats of Satin Black on the bed sills.
20171009_152534 by
bjohnson388, on Flickr
This tailgate is a mess. It is bowed, which I think I can get most of it out its only on the top. It has several deep dents on the bottom that I will have to drill a hole and use the slide hammer to pull out and then weld back up.
20171009_143228 by
bjohnson388, on Flickr
20171009_143233 by
bjohnson388, on Flickr
The bow in the top.
20171009_143238 by
bjohnson388, on Flickr
Someone used it as a workbench too much. SMH.
20171009_143257 by
bjohnson388, on Flickr
Pulled out the other bedside and started stripping didn't finish but got a good start.
20171009_143608 by
bjohnson388, on Flickr
It is in alot better shape than the other side.
20171009_143613 by
bjohnson388, on Flickr
20171009_152745 by
bjohnson388, on Flickr
Both stake pockets need some attention.
20171009_152748 by
bjohnson388, on Flickr
20171009_152753 by
bjohnson388, on Flickr
20171009_154823 by
bjohnson388, on Flickr
And that concludes my vacation progress.
Thanks for stopping in,
Bret