View Single Post
Old 02-28-2019, 08:55 AM   #4
T/C
Registered User
 
T/C's Avatar
 
Join Date: Aug 2009
Location: Krum Tx.
Posts: 267
Quote:
Originally Posted by PGSigns View Post
If mine i would go a bit forward and leave the trans cross member intact till your done welding it up. Rest of the plan seems OK. We used a bolt together chassis jig made from 6" H-beam that we would level up and could tack weld the lower rails to. We were building drag cars but it works for any thing you want to be able to keep straight and square.
Jimmy

Thanks after coming in and thinking over everything i think i was over thinking using a flat section where it begins to narrow. As long as cuts are right it will still line up and shouldn’t be a issue.

I guess stepping away really is good sometimes.

As for jigs we are going to have several areas covered to be sure it all stays good and square and to do the movement.

I have done several frames just never modified one always started from scratch.

Thanks for your time!
Posted via Mobile Device
T/C is offline   Reply With Quote