View Single Post
Old 03-08-2019, 08:14 AM   #4
Registered User
T/C's Avatar
Join Date: Aug 2009
Location: Krum Tx.
Posts: 267
Re: Laying frame on stock radius arms

The front already has a 3” z will be getting 3” spindles and if i need a tad more after i will section the crossmember.

I figured this was the best route and probably going to make that next step and just cut it up..

The botch has all the room i need to lay frame as is I’m just to poor to properly utilize it.
T/C is offline   Reply With Quote