View Single Post
Old 03-19-2019, 10:45 PM   #3
AZ 67 C10
Registered User
 
AZ 67 C10's Avatar
 
Join Date: May 2017
Location: Goodyear, AZ
Posts: 70
Re: Ball Joint Taper

I increased the taper on my spindles to accept larger tie rods (73-87) since the rest of my suspension was 73+ and my spindles were 67-70. I cant speak for all the different years and suspension components but my setup was a 7 degree taper. There's some math involved to figure the degrees of taper so don't quote me on it being 7 degrees since I could have totally done the math wrong.. In the end I took it to a machine shop since my tapered bit was chattering when I tried to do it.
AZ 67 C10 is offline   Reply With Quote