[dwcsr]

I needed some line separators for the PS hoses and the prices for the ones I wanted were $12- $15 each. I needed 4 and it seemed like a lot for what they are. I had some aluminum stock and this is the result. $2.00 in metal and 3 hrs time. I drilled the sizes I needed, cross drilled and tapped a 10-32 hole for a stainless steel screw to hold the halves together. Then cut each off the stock, then cut them down the center. I used a mill file to shape them and sand paper to smooth the out. Once they are polished on the buffer they will look just like the ones I wanted. If you make these just remember to drill a larger hole in the top half so the screw will slide in and screw into the bottom.