The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Adding body side molding from Mar-K

NEWFISHER · 10-02-2013, 06:01 PM

So far so good. I have the left side done. I opened all of the moldings to do the right side and the upper rt bedside molding has some visible compressions in it. Called Mar-K and emailed some pic's. Not what I was planning on, oh well. Right side will have to wait a bit.

Stopped at Multicraft plastic and picked up some 1/4" plastic, ripped it into 3/8 wide strips to set down into the molding. Cleaned , scuffed and applied 3/8 .040 3M tape, attached molding and added another 3/8 .040 piece. wiped the side with alcohol and measured down 1 1/2 inch to the top and slapped them on. Easy peasy no holes.

10-02-2013, 06:01 PM	#19
NEWFISHER Registered User Join Date: Sep 2012 Location: Oregon Posts: 3,303	Re: Adding body side molding from Mar-K So far so good. I have the left side done. I opened all of the moldings to do the right side and the upper rt bedside molding has some visible compressions in it. Called Mar-K and emailed some pic's. Not what I was planning on, oh well. Right side will have to wait a bit. Stopped at Multicraft plastic and picked up some 1/4" plastic, ripped it into 3/8 wide strips to set down into the molding. Cleaned , scuffed and applied 3/8 .040 3M tape, attached molding and added another 3/8 .040 piece. wiped the side with alcohol and measured down 1 1/2 inch to the top and slapped them on. Easy peasy no holes.