Quote:
Originally Posted by ulakovic22
What part of the trailing arm cross member causes the interference? Is it the whole width of the x-member that you have to notch the floor or is it just the center section? Is there any design modification to the x-member that could be done to alleviate the interference?
|
I don't think I took a pic of the notch... at least I can't find a pic yet! The "v" on the upper tube of the trailing arm x-member pokes into the cab about an inch. The length of the notch was about 12" wide. I made it a little bigger than it needed to be.
Nate