[OutlawDrifter]

Shop time last night went well. I ended up with more accomplished than expected. I was hoping to get the inner fenders trimmed, and ended up getting the inner's trimmed, complete fenders hung, and the core support started for test fitting. Nice to have more of the sheet metal hanging on the GMC...even if I have to pull it all back off again!

Everything is tight in the engine compartment. Looks like I'll have about 3.5" between the water pump and radiator. Need to figure out how I will attach my core support. Not sure if I want to go directly to the frame rails like Skymang or do a cross member with risers like Hussey.

What's the best way or method to "set" the height for the core support? All ideas are welcomed.