well heres pics as promised, all in all the installation went smoothly so far. I have the crossmember all bolted up and in the correct drop position, along with my headers put on. I also started to run the wiring and thats where i quit today.
Funniest thing that happened, I was using a master lock as a chain link while installing the motor, and, long story short it bumped the firewall and broke the key off inside the lock, so then i had to cut it off with a torch!
Motor mocked up on stand. I like my free headers!
its gettin there...
i think the body cleaned up nicely...
Soooo close...
And there it is! That little 355 really likes its new home!
Tomorow I will finish bottoning up the motor, add gas, oil, and tranny fluid, and give it a go!