The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

MARTINSR · 06-15-2018, 09:51 AM

Another thing is depending on where it's at you can use an adhesion promotor. https://www.autobodytoolmart.com/3m-...CABEgLnFvD_BwE

We use this everyday at the shop on the parts that may require a bit more or they were dirty and we need to make sure it's clean.

What mouldings are you using this tape on, a late model truck? Those big mouldings on a late model GM truck can be REALLY tough. Warm them up, be sure they are going on flat and not pulling up on the ends. I have seen WAY too many of the, fail at the ends so I put a dab of window urethane on them at each end.

Brian

06-15-2018, 09:51 AM	#5
MARTINSR Registered User Join Date: Dec 2000 Location: Boise, Idaho Posts: 6,001	Re: 3m super strength molding tape Another thing is depending on where it's at you can use an adhesion promotor. https://www.autobodytoolmart.com/3m-...CABEgLnFvD_BwE We use this everyday at the shop on the parts that may require a bit more or they were dirty and we need to make sure it's clean. What mouldings are you using this tape on, a late model truck? Those big mouldings on a late model GM truck can be REALLY tough. Warm them up, be sure they are going on flat and not pulling up on the ends. I have seen WAY too many of the, fail at the ends so I put a dab of window urethane on them at each end. Brian __________________ 1948 Chevy pickup Chopped, Sectioned, 1953 Corvette 235 powered. Once was even 401 Buick mid engined with the carburetor right between the seats! Bought with paper route money in 1973 when I was 15. "Fan of most anything that moves human beings"