The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - What did you do with your truck today, Part 3

MARTINSR · 05-22-2018, 11:10 PM

I got the area over the right corner window that I planished into shape last night welded. Then I got the lower inside piece shaped and ready to weld in after I clean up the rust and protect it with paint on the back side of the pieces. The real big accomplishment tonight was to figure out what I was going to do with all these inner pieces. I got a plan that I didn't have before tonight, I am stoked!

I just want to rave about my Spitsnagle spot weld driller again. DAMN that thing works awesome! I wanted to remove that piece, just simply "unbolt" the welds, it's that easy.

Brian

05-22-2018, 11:10 PM	#995
MARTINSR Registered User Join Date: Dec 2000 Location: Boise, Idaho Posts: 6,001	Re: What did you do with your truck today, Part 3 I got the area over the right corner window that I planished into shape last night welded. Then I got the lower inside piece shaped and ready to weld in after I clean up the rust and protect it with paint on the back side of the pieces. The real big accomplishment tonight was to figure out what I was going to do with all these inner pieces. I got a plan that I didn't have before tonight, I am stoked! I just want to rave about my Spitsnagle spot weld driller again. DAMN that thing works awesome! I wanted to remove that piece, just simply "unbolt" the welds, it's that easy. Brian Attached Images __________________ 1948 Chevy pickup Chopped, Sectioned, 1953 Corvette 235 powered. Once was even 401 Buick mid engined with the carburetor right between the seats! Bought with paper route money in 1973 when I was 15. "Fan of most anything that moves human beings"