View Single Post
Old 09-19-2020, 07:53 PM   #16
CG
BlahBlahBlah
 
Join Date: Feb 2002
Location: Monroe, Wa.
Posts: 19,769
Re: Blank METAL instrument bezel??

Quote:
Originally Posted by LS short box View Post
Correct I used the sheet metal to locate the gauge holes in the bezel. Scribed the holes and then used a die grinder to make the gauge hole. I used 5" Auto Meter tach and speedo. Oil, volt, gas and temp are 2 1/6" gauges. In the middle between the speedo and tach I used a 2 1/6" gauge I gutted for the high beam and left and right turn signal. Lots of time in MN winters to do this stuff.
Not usually a fan of aftermarket gauges substituted, but you really pulled it off, looks great!
__________________
… … … … … … … … ... … … … … … … … … … … …

Monroe Swap meet May 18-19.
Mike has the same spots for the NW guys he's had forever.
Lunch time BBQ at the spaces.
If you have stuff to sell bring it along.

If you have a question PM stllookn (Mike) here via the board.


https://67-72chevytrucks.com/vboard/...d.php?t=851291
CG is offline   Reply With Quote