The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Daddy Brim** · 04-28-2012, 10:37 PM

I have 67 C-20 a while ago I had front brake failure, broke rubber line. since then I have replaced all rubber lines, calipers, shoes, and springs. I'm trying to bleed the system and it appears that I have all of the air out, not seeing any air bubbles when I open the bleeder. It appears the amount of fluid coming out the back is more than the front. There is no brake peddle, and I wound doubt it is the master cylinder as everything was fine before brake line broke. I have tried to do some research some say the distribution block needs to be reset others there is nothing to reset. What do I need to do to fix these brakes? I'm at my wits end. This is the distribution block that is in my truck.

04-28-2012, 10:37 PM	#1
Daddy Brim Senior Member Join Date: Feb 2011 Location: Clovis Ca. Posts: 632	Resetting a 67 distribution block ? I have 67 C-20 a while ago I had front brake failure, broke rubber line. since then I have replaced all rubber lines, calipers, shoes, and springs. I'm trying to bleed the system and it appears that I have all of the air out, not seeing any air bubbles when I open the bleeder. It appears the amount of fluid coming out the back is more than the front. There is no brake peddle, and I wound doubt it is the master cylinder as everything was fine before brake line broke. I have tried to do some research some say the distribution block needs to be reset others there is nothing to reset. What do I need to do to fix these brakes? I'm at my wits end. This is the distribution block that is in my truck. Attached Images __________________ I'm sorry I called you stupid. I thought you knew already. 67 C-20 Custom Camper 68 Nova 396 it does wheelies 2005 Buick Century the one the wife drives 1989 Toyota Tercel to drive when I can't put gas in the first 2. Last edited by Daddy Brim; 04-29-2012 at 08:45 AM.