[chevybuilder18]

Well i examined my CS130 and i found those letters right there were you plug the connector to. im serious when i say i dont have the connectors. but i did have some old useless coil in cap wiring connectors, had the female for the prongs, had to cut them in half with a knife but, and put them in. one i kept part of the plastic casing on, making it were it wouldnt short out. since the female connectors look like there for bigger prongs i had to break the plastic for the L connector which i wrapped in electrical tape, but the S connector has plastic on it but i still wrapped it for tight fitting on prong and position. for good measures, electrical tape was used to insure no bad luck. so any ways i made the female connectors tighter and narrower so they can fit these prongs. hows that for a free set up? whats next?