Quote:
Originally Posted by chewychevy67
Looking good!
|
Thanks uncle! I finally got the welder all dialed in and working nice.
I was finally able to finish my lower firewall piece off today. I did end up having to cut out a section in the middle and replace it due to warping from my poopy welds, but I managed to get it completed.
I also got started on my foot well. I was able to clean out the inside of my front pillar quite nicely but I don't have any weld through primer. So I figure that's ok, Ill go raid my dads shop.
Turns out he only had a quarter of a can and I could not get it to spray. More or less just spits out so I was not able to weld in my piece.
Haha oh well, hopefully I can find some tomorrow. Anyways I will get to the part of my post that keeps this site going!
PICTURES!