The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

CSHADES · 03-08-2018, 03:33 PM

joedoh I used a piece of 3/8" rod and bent it to match the curve of the fender, tack welded it to my patch and then hammered the sheetmetal over the rod to get the rolled edge. Then cut the tacks off of the rod and finished the roll.

03-08-2018, 03:33 PM	#26
CSHADES Registered User Join Date: Nov 2015 Location: portage wi Posts: 502	Re: project 39 joedoh I used a piece of 3/8" rod and bent it to match the curve of the fender, tack welded it to my patch and then hammered the sheetmetal over the rod to get the rolled edge. Then cut the tacks off of the rod and finished the roll. Last edited by CSHADES; 03-08-2018 at 07:25 PM.