|
Re: Dad's 1979 GMC Heavy Half Transformation
Been collecting parts most of the winter. I plan on taking the 85 cab and putting it on the 77 frame. Took all my 73-80 extra interior pieces and parts and fitted them into the 85 cab. Will have to adjust a couple things on the dash and dash pad. Will have to slide over the VIN opening on the dash pad before I get it recovered; and, figure out the 1979 dash bezel where I'll need to switch around the light pull-switch and wiper switch, that shouldn't be a problem. NOS parts (doors, fenders, valance, bumper and hood) will be going on this "clone 78 Silverado."
The plan is to go back to my original plan and complete my Dads 1979 GMC Heavy Half and put it back to original! HOOOAH! I have all the parts to complete that project, to include 350/350 that need rebuilt. Even have the NOS full-set of LWB trim. I'm looking forward to that build down the road; It'll be so much easier.
Also found a mid-70s LWB wood bed floor with inner fenders. That was a PITA to take about. Has some rust, but nothing too difficult. Also just picked up two LWB 80s square hole bedsides, rust free with minor dings etc.
Enjoy!
|